* If the high note seems to come up a little flat, check to see if the string is binding in the nut or the bridge. Just remember that the stop for the higher note is set with the black thumbscrew. * Other tunings may be used besides the one described. Set the high stops with both strings raised, and the low stops with both strings lowered. * When setting the stops, always tune up to the high note and down to the low note.
If you prefer to wind one or both of your strings in the opposite direction, just swap the black and uncolored thumbscrews on the appropriate tuner. * NOTE: These directions assume that the strings are wound on the spools in the normal manner that is, the pitch of the second string is raised by turning its tuner counterclockwise, and the pitch of the third string is raised by turning its tuner clockwise. The above drawing illustrates the recommended placement of the four tuner buttons when the banjo is tuned gDGBD.ġst string tuner button should be placed diagonally toward the center of the peghead.Ģnd string tuner button should be placed parallel with the strings.ģrd string tuner button should be placed perpendicular to the strings.Ĥth string tuner button should be placed diagonally toward the center of the peghead. The shaft of the peg is splined, enabling you to remove the button and place it to your liking. Keith Tuners are designed with this in mind. Tuner Button Placement (looking at back of peghead)Įxperience has shown that placement of the tuner buttons affects the ease and speed of playing. Push it back on the shaft and screw in the end thumbscrew.
Banjo tuner free install#
Since the button will fit on the shaft in six different positions, you can install it at the angle that suits you best.
Banjo tuner free free#
If the pearlescent buttons are not at a convenient angle to turn while playing, simply unscrew the end thumbscrew that holds the button in place and pull the button free of the shaft. and will not turn past the high or low stops.ģ. The tuners will now operate as “D-tuners”. Now, tune the second string down to A and the third string down to F# (put the banjo into open D tuning) and firmly tighten the uncolored side thumbscrews. Firmly tighten the black side thumbscrews, which will set the high stops. Tune the banjo to the open G tuning (second string – B. Now put on the second and third strings.Ģ. The Keith Tuners will operate like standard tuning pegs. Loosen all four side thumbscrews one-half a turn.
If the holes in your banjo’s headstock are too small for the Keith Tuners, we recommend having them drilled out by a qualified instrument repairman.ġ. Pliers will scar the metal, and may slip off and damage the headstock. * PLEASE NOTE: When tightening down the nuts, use a smooth-jawed adjustable wrench. Similarly, install the Keith Tuner with the smaller spool for the third string. Put the flat washer and the nut back on, and tighten securely.ģ. Remove the nut and washer and insert it through the headstock, positioning it so that the two side thumbscrews can be conveniently reached while tuning. The Keith Tuner with the larger spool is for the second string. and you’ll notice that the spools on which the strings wind are of different sizes.Ģ. Remove the 2nd and 3rd strings and tuning pegs from your banjo. FAQ (Frequently Asked Questions) How do I install my tuners?ġ.
0 kommentar(er)
